Sonax CC One v2 is the simplest and most user-friendly long-term ceramic coating available! The CC One v2 is the new version of the previous CC One, which was so popular with both DIY detailers and professional detailers because it is a single coating that only requires one layer to be applied. This means you don't have to spend a long time coating your car. You can treat an entire car in just 45 minutes!
The CC One V2 is very easy to apply with the included sponge applicators. There is enough product and applicators to treat one large SUV or two smaller cars. You can apply multiple layers of CC One to the paintwork, but this will not double its lifespan. When applying one coat, Sonax guarantees a durability of three years or approximately 30,000 km. If you want to apply a second coat, we recommend allowing one and a half hours drying time between coats.
To achieve the best performance and longest durability of the coating, it is important to give the paintwork a good pre-treatment. This involves washing the car thoroughly, removing iron particles and tar, giving it a clay treatment, and preferably also polishing the car. After that, it is necessary to degrease the paintwork with a surface degreaser such as Sonax Prepare.
Once the car is prepared, open the product and apply 4-5 drops of Sonax CC One V2 to the white side of the application sponge. This will allow you to treat an area of approximately 50x50cm. It is important to apply the product thinly to the surface in horizontal and vertical overlapping movements to ensure even distribution of the product. If the applicator sponge starts to harden, it is best to use a new applicator.
After about 2 to 3 minutes, the coating is ready to be removed with a microfiber cloth. We recommend using a thick microfiber cloth without edges, such as the Sonax Coating Towel. After removing the coating with a microfiber cloth, we recommend using a new microfiber cloth to go over the area again, extending 10 centimeters beyond the area to ensure that everything has been removed. Regularly take a new, clean microfiber cloth and throw away the old used microfiber cloths. The excess coating will harden in the microfiber cloth, creating small crystals that will damage the paintwork the next time the microfiber cloth is used.
After applying the coating, it is important to keep the car dry for the first 4 hours and not to use any chemicals. Because this coating is so user-friendly and dries quickly, it is the perfect solution for someone with little experience and for people without a garage. You can apply this coating in a clean, dry place in the shade. Please note that the warmer the climate, the faster the coating will dry when you apply it. As a result, the standard drying time of 3 minutes may be reduced to just 1 minute. If you find that the coating is more difficult to remove, you may need to wipe it off more quickly.
The coating will continue to cure after the first 4 hours, but will already be resistant to water. However, to protect the coating during its most vulnerable period, it is recommended not to wash the car during the first week.
Zelf installeren
Laten installeren
Garantie
Display
Achteras Ratio
Drag Race Mode
Launch Control
Kickdown Launch
Vertrekken in 2e
Stilstaan in 2e
Verhoogde druk